







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Belgard Bathroom Remodeling: The East Los Angeles Owner’s Guide
Bathroom remodeling in East Los Angeles with Belgard-spec materials typically runs $10,620 to $33,040 installed, and yes, we can usually get a written scope and price to you the same day you call. When a Belgard-surface bathroom project fails early, it almost always shows up the same way: grout lines at the shower base go dark and won’t scrub clean, a floor tile sounds hollow underfoot, or the ramped curb edge starts to crumble after a few seasons of hard water. Owners call us after a previous installer told them the “settling” was normal. It isn’t.
Bradford Remodeling Co East Los Angeles is an independent service provider. We’re not affiliated with Belgard; we install according to manufacturer specs so the material’s own warranty stays intact.
Which Belgard Models This Applies To

Belgard is a hardscape brand first, which is exactly where most of the confusion starts. In a bathroom, Belgard shows up in three places: paver-style floor tile, threshold and curb pieces, and wall or accent veneer. The floor tile lines most East Los Angeles homeowners end up with are in the Mega Bergerac and Urbana Stone families; thresholds are usually cut from a Belgard curb or bullnose paver matched to the floor. That matters, because the threshold is a different thickness spec than the tile bed, and a 2-inch curb piece set on a 1.5-inch tile bed will not sit flush.
To identify what you have, pull the original box if it’s still in the garage, check the underside of a spare piece for a molded stamp, and measure the actual face: Belgard pavers run in standard nominal sizes (4×8, 6×9, 6×12, 12×12), and the grout joint width tells you whether the installer followed the 1/8-inch minimum the spec calls for.
On the OEM-versus-aftermarket call: for a whole-floor replacement, matching Belgard is worth it because color and texture batches across suppliers don’t match, and Belgard runs a factory color-match process. For a single chipped threshold piece, a quality aftermarket equivalent cut to spec is often the smarter buy and won’t be visible once grouted.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Belgard Bathroom Remodeling Is Failing
- Grout failing at the shower base. Dark, crumbly mortar there means water is getting past the tile face into the substrate. In East Los Angeles homes with original 1950s cast iron plumbing and no vapor barrier behind the wet wall, that failure runs deeper than a regrout.
- Hollow sound tapping the floor. A hollow note means the thinset bond has broken and the paver is no longer supported. Left alone, that paver cracks at the edge and the adjacent pieces start lifting.
- Efflorescence on the wall or threshold. White mineral powder that keeps coming back after you wipe it is moisture migrating through the material. It’s the early, visible stage of a substrate problem.
- Lipped or uneven grout joints. A step you can feel between two tiles usually means the substrate wasn’t flat before setting. It’s a workmanship failure, not a Belgard failure.
- Cracked threshold curb. Overloaded water absorption at the curb is common where the shower door puts a load across a brittle cut piece. Cracks there usually spread within a season.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Belgard bathroom remodeling in East Los Angeles prices as follows. These are installed ranges, parts and labor together, so you’re comparing the same number on every bid.
- Full bathroom remodel: $10,620 to $33,040
- Small bathroom remodel: $5,900 to $14,160
- Walk-in shower installation: $5,310 to $14,160
- Tub-to-shower conversion: $4,130 to $11,800
- Shower replacement: $3,540 to $10,030
- Bathroom vanity installation: $945 to $3,540
The top of the range reflects a full gut: new substrate, waterproofing membrane, Belgard floor and curb, and Kohler or Moen fixtures. Material type drives the number hardest; Belgard paver-style surfaces run higher than standard ceramic. Every Bradford project starts with a written price before any work begins, and the completed work carries the 365-Day Done Right Promise: if it fails inside that full year, we return and correct it at no charge. We also work with KraftMaid, Cambria, and Silestone for the cabinetry and counter side of the room.
DIY or Call Us?
You can safely check the damage scale yourself. Lift a loose paver, note whether the thinset is intact underneath, photograph the failing grout, and confirm the material type from a spare piece. That’s enough to get an accurate price on the phone.
Where it goes wrong: a bathroom is a wet environment, and the waterproofing layer behind the tile is a code and manufacturer-spec requirement, not a suggestion. A DIY Belgard install that skips or breaks the membrane behind a shower will fail within a season or two, and it voids the material warranty. This isn’t a fall hazard the way a roof is, but the water damage behind a failed shower pan reaches subfloor framing and quiet rot, and that turns a $5,310 shower job into a much larger one. Call us at (833) 520-6636 for a free estimate and we’ll tell you honestly which scenarios are worth doing yourself.
FAQs

A properly installed Belgard bathroom installation should hold for 20-plus years with the wet-area joints resealed every 3 to 5 years. In East Los Angeles, the harder municipal water accelerates mineral buildup on grout lines, so resealing on the shorter end of that range keeps the surface looking right. Call (833) 520-6636 for a free estimate if you’re seeing a failure earlier than that.
Sometimes. A single cracked paver with intact substrate can be swapped and re-grouted for a much smaller line item than a full replacement. If the underlying substrate is soft or the waterproofing failed, replacement is the honest answer. Call (833) 520-6636 and we’ll tell you which one you’re looking at.
A single-piece or small-area replacement is a short job, often a day or two. A full bathroom remodel in East Los Angeles typically runs 3 to 6 weeks depending on scope, plumbing rework, and inspection scheduling. Call (833) 520-6636 for a written timeline with your free estimate.
We source Belgard material through manufacturer-authorized distribution so the color batch matches what you already have and the material warranty holds. Where a single threshold or curb piece is out of production, we cut a matching paver to spec rather than substitute an off-brand piece. Call (833) 520-6636 to confirm availability for your specific Belgard line.
Written by the team at Bradford Remodeling Co East Los Angeles, serving East Los Angeles and nearby areas.












