







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CWS Driveway & Pavers: The East Los Angeles Owner’s Guide
We install CWS-compatible paver driveways and hardscape in East Los Angeles, and a full paver driveway install runs $8,260 – $21,240 on the low-to-high end for a typical residential apron and run. CWS pitch and settlement problems usually show up as one paver that rocks under your foot before the rest of the field starts to cup and shift. In East Los Angeles, that first rocker is the tell: our expansive clay subsoil moves with every wet season, so a settling paver base is a base problem, not a surface one.
Which CWS Models This Applies To
CWS paver and driveway systems break down by series and profile, and the profile matters more than the color name. CWS runs both a classic interlocking profile and a straight-edge slab profile, and the joint geometry is not interchangeable between them. If your drive uses an interlocking 60mm paver, the field course is set on a compacted aggregate base with a geotextile separator; if it uses the slab-style profile, the setting bed and edge restraint are different animals entirely. Pull a fail-check first: measure one paver face and its thickness, and note whether the edge course is soldier or running bond. The label on a factory pallet or the original invoice is the fastest identification route. On the OEM-versus-aftermarket decision, CWS-profile pavers are widely matched by compatible aftermarket sources that reproduce the same footprint, so you can buy the matching piece without paying a discontinued-series premium when the original colorway is out of production.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CWS Driveway & Pavers Is Failing
- One paver rocks when you step on it. That paver has lost contact with its setting bed, usually because the base under it was under-compacted or water found a real path through the joint sand.
- The field cups or dips toward the garage. A dip toward the door means the base grade has settled or the original drain slope was shallow, so rainwater pools instead of running off.
- Joint sand washes out after rain. Grooved, eroded joints let water into the base, which speeds up settlement and loosens neighboring pavers.
- Edge pavers spread or tip outward. The edge restraint has failed or was never pinned deep enough, so the field has nothing holding the outer course in place.
- Efflorescence or dark wet patches. White leaching or a damp-looking zone points to moisture trapped under the field, a slow leak or a base that never fully drains.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In East Los Angeles, a paver driveway installation ranges $8,260 – $21,240, with the range driven by square footage, base depth, edge restraint, and whether old concrete or failing pavers must be demoed and hauled. A concrete driveway installation runs $5,310 – $14,160, asphalt paving $4,130 – $10,620, and a full driveway replacement $5,900 – $16,520; sealing alone is $295 – $825. Our written price lists parts, base prep, setting bed, edge restraint, joint sand, and labor line by line before any tool comes out, and it does not move at the door. Every completed install carries the 365-Day Done Right Promise: if the work fails inside that window, we come back and correct it at no charge.
DIY or Call Us?
You can safely check surface symptoms yourself: press for rockers, look at whether water pools toward the garage, and probe joint sand depth with a screwdriver. What you should not do is pull up a field of pavers to reset the base. A driveway base is structural – if it is under-compacted or the drainage is wrong, resetting pavers on a bad substrate fails again the first wet season, and a broken edge restraint can shift enough material to make the job bigger than it started. The base is the work. Call us at (833) 520-6636 and we’ll give you a written price before any work begins.
FAQs

A properly based paver driveway lasts 25 to 50 years; the pavers themselves outlast the base in our climate. The limiting factor in East Los Angeles is the subsoil movement and drainage, so base prep and edge restraint decide the real lifespan, not the paver face.
Yes, in many cases a localized repair resets the affected field and the edge course and re-sands the joints. If the base is uniformly settled or the drainage is failing, a full re-base is the honest call, and we’ll tell you which one you’re looking at before you spend.
A standard residential install typically runs several days from demo through joint sand and cleanup, depending on square footage and base depth. We give you the schedule in writing with the price so you know what to plan around.
We match the exact CWS profile and thickness from your original labeling or measurements, then source the compatible paver through documented supply channels so the piece and its manufacturer specs are traceable. We don’t carry parts or stock pavers – we order the right match for your drive.
We’re an independent service provider and are not affiliated with CWS. We also work with KraftMaid, Cambria, and Silestone products on the remodeling side, and every job is held to The Garrison Standard: a written price before work starts, background-checked uniformed technicians, and a live person on the phone 24/7.
Call (833) 520-6636 for a free estimate on your CWS driveway and paver project in East Los Angeles. You’ll get a written, line-item price and a clear scope before anything begins.
Written by the team at Bradford Remodeling Co East Los Angeles, serving East Los Angeles and nearby areas.












